Comments on: The ‘ShoulderLander’ – Shoulder Support for a Canon XH-A1 http://www.overlander.tv/2007/the-shoulderlander-shoulder-support-for-a-canon-xh-a1/ round the world travel video adventure Tue, 07 Feb 2012 13:54:11 +0000 hourly 1 http://wordpress.org/?v=3.3.1 By: Craig Hodges http://www.overlander.tv/2007/the-shoulderlander-shoulder-support-for-a-canon-xh-a1/comment-page-1/#comment-248 Craig Hodges Thu, 17 Jan 2008 21:37:14 +0000 http://www.overlander.tv/2007/the-shoulderlander-shoulder-support-for-a-canon-xh-a1/#comment-248 Very ingenious Mark. I do see what you mean about 3mm piece to be bent to fit your shoulder though. Mind out. You might be getting orders placed. All the best. Craig Very ingenious Mark.

I do see what you mean about 3mm piece to be bent to fit your shoulder though.

Mind out. You might be getting orders placed.

All the best.

Craig

]]> By: Jan / The Faux Press http://www.overlander.tv/2007/the-shoulderlander-shoulder-support-for-a-canon-xh-a1/comment-page-1/#comment-195 Jan / The Faux Press Wed, 28 Nov 2007 08:22:58 +0000 http://www.overlander.tv/2007/the-shoulderlander-shoulder-support-for-a-canon-xh-a1/#comment-195 Gosh, I'm envious of you folks who can make practical, worthy stuff out of your hands, heads and the stuff of garages. Bravo! If you were to make a bend at the end to give the device further stability I would think an additional advantage would be a sliding plate and bolt for length adjustment (for the commercial rather than custom market). Good luck with that! Gosh, I’m envious of you folks who can make practical, worthy stuff out of your hands, heads and the stuff of garages. Bravo! If you were to make a bend at the end to give the device further stability I would think an additional advantage would be a sliding plate and bolt for length adjustment (for the commercial rather than custom market). Good luck with that!

]]>